Windows 7 sleep mode settings

You can follow the same method given above to turn off the sleep mode for Windows 10 too via control panel or just follow the below shortcut method:. The below-given commands can be used to enable or disable the sleep mode in Windows 10, 8, and 7 via command prompt. The value given in the front of ac or dc will enable or disable the sleep mode. You can enable or disable the turn off of the display via the same command just you have the change the settings value.

For complete powercfg command details please see the official Microsoft link. If you have any query related to enable and disable of Windows sleep mode, please let us know via comment section. This site uses Akismet to reduce spam. Learn how your comment data is processed. Click Start , type power sleep in the Start Search box, and then click Change when the computer sleeps.

In the Put the computer to sleep box, select a new value such as 15 minutes. However, make sure that you do not select Never. Then, click Change advanced power settings. Expand Sleep , expand Allow waker timers , and then select Disable. Note This setting prevents programs from waking your computer. If you want a scheduled task to wake your computer, you have to change this setting back to Enable. Expand Multimedia settings , expand When sharing media , and then select Allow the computer to sleep.

Note This setting lets your computer go to sleep even if you share media libraries with other computers on your home network. For the last step, try to disable any devices that might wake your computer.

To disable these devices, follow these steps:. Start an elevated command prompt. To do this, click Start , type cmd in the Start Search box, right-click cmd , and then click Run as administrator. To disable a specific device from waking the computer, run the following command, or use Device Manager :. Powercfg -devicedisablewake " devicename " Note Make sure that you replace the devicename placeholder with the name of the device that you want to disable.

If this issue still occurs after you disable one device, disable the devices in this list one by one until you determine which device is causing the issue. If you want to re-enable a device to wake the computer, run the following command:.

You can also use Device Manager to disable or enable a device to wake the computer. Some of the settings are clear and simple. Others may require some more explaining. In the actual Sleep mode, the computer doesn't turn off completely and still uses a lot of energy to power the RAM. Monitor and hard disk are turned off, but as soon as you touch the mouse, the computer wakes up. Hibernate means that the computer essentially turns off, but first the RAM is saved on the hard drive.

When you reboot the computer, the RAM is loaded from the hard drive, so that you can continue where you left. This procedure can take a minute or two. Hybrid Sleep is a mix of sleep and hibernate.

The computer will go into sleep mode, but it will also save the RAM to the hard disk. If the battery runs out or power fails while during hybrid sleep, the computer will reboot as if it had been in hibernate.

Wake Timers allow the computer to be woken from sleep or hibernate, for example in response to a scheduled task set respective trigger condition. This can be used to run backups and other remote tasks during the night.